Skip to content
218 Cultivation

AC Infinity HYDRONE 7 Hands-On Review

Posted · 13:57 · Watch on YouTube

Unboxing and setting up the HYDRONE 7 in a real grow space. Setup, controls, first impressions, and how it fits into a tent environment. A solid look if you've been hunting a better way to manage humidity.

Chapters

  1. 0:00Intro
  2. 0:33What this video covers
  3. 1:50Unboxing
  4. 2:46What makes it different
  5. 3:20Placing it in the tent
  6. 5:20Hooking it up
  7. 5:47Water tank and drain hose
  8. 7:23Programming it on the controller
  9. 9:34Humidity test
  10. 11:20Results
  11. 12:12What I like

Notes from the video

  • AC Infinity rates it for tents up to 8x8, with 10 drying levels, dual 6 inch duct ports, and control through their UIS controllers. They say it can pull humidity as low as 25%.
  • It can sit inside the tent, or run ducted as an open or closed loop. Ducting is not included.
  • It is fairly big. In a 4x4 tent it takes up a good amount of floor space.
  • Water goes into a tank of about half a gallon, or out through the drain hose. If your room runs wet, use the drain from the start.
  • Programmed on port 6 with a humidity trigger: it turns on above 61% and runs until the tent is back under.
  • Test with the exhaust fan off: at level 10 it took the tent from 90% humidity down to 60% in about 7 and a half minutes. Tent temperature rose from 60°F to 74°F while it ran.
  • It does not need a controller. It has its own sensor probe and onboard controls, so it works on its own too.

10% Off Store-Wide

Get My Code
Shop AC Infinity

Affiliate link. 218 Cultivation may earn a commission at no extra cost to you. Details.

More AC Infinity videos

All AC Infinity videos

Affiliate Partner · Real-World Testing