How to Automate CO2 in Your Grow Tent
Posted · 11:32 · Watch on YouTube
Full AC Infinity setup guide for a fully automated CO2 system. Walks through the regulator install, the Bubble Test safety check, and programming the Controller to hold perfect PPM levels on its own.
Chapters
Notes from the video
- The brain is the Controller AI+. The AI 4-outlet or 8-outlet controllers can do the same job and give you extra power sockets.
- The CO2 regulator has a solenoid valve, which is what stops the gas. It plugs into a UIS control plug so the controller can switch it, and UIS wireless transmitters save running cables across the tent.
- A 20 lb tank. Buying it empty online and swapping it for a full one at a welding or gas shop saved me about $50 to $60.
- A 1/4 inch tubing kit with micro holes drilled in it, run along the bars above the light so the CO2 trickles down over the canopy.
- Bubble test: spray soapy water on the connection, open the tank, and watch for bubbles before you trust the seal.
- Programming: Sensor Trigger, CO2, set to 800 ppm. It turns on below 800 and shuts off once it gets there.
- Optional settings: a buffer so it does not flicker on and off at exactly 800, and a maximum run time (5 minutes, say) so a stuck valve cannot empty the tank.
- Turn on the photocell so it only doses while the lights are on.
- Result: when the tent drops to 800 the regulator kicks in, the level jumps to about 1,000, then slowly trickles back down.
10% Off Store-Wide
Get My CodeAffiliate link. 218 Cultivation may earn a commission at no extra cost to you. Details.
Go deeper
More AC Infinity videos
AC Infinity Controller AI+22:15
AC Infinity Controller 69 Pro Setup18:01
AC Infinity Propagation Tent Review8:11
AC Infinity Soil Sensor: Real-World Test9:48
AC Infinity HYDRONE 7 Hands-On Review13:57
Affiliate Partner · Real-World Testing
