Skip to content
218 Cultivation

How to Automate CO2 in Your Grow Tent

Posted · 11:32 · Watch on YouTube

Full AC Infinity setup guide for a fully automated CO2 system. Walks through the regulator install, the Bubble Test safety check, and programming the Controller to hold perfect PPM levels on its own.

Chapters

  1. 0:00Intro
  2. 1:08The gear list
  3. 3:47Running the tubing
  4. 5:18Connecting the regulator to the tank
  5. 6:30The bubble test
  6. 7:08Connecting to the controller
  7. 8:10Programming the CO2 trigger
  8. 10:20Results

Notes from the video

  • The brain is the Controller AI+. The AI 4-outlet or 8-outlet controllers can do the same job and give you extra power sockets.
  • The CO2 regulator has a solenoid valve, which is what stops the gas. It plugs into a UIS control plug so the controller can switch it, and UIS wireless transmitters save running cables across the tent.
  • A 20 lb tank. Buying it empty online and swapping it for a full one at a welding or gas shop saved me about $50 to $60.
  • A 1/4 inch tubing kit with micro holes drilled in it, run along the bars above the light so the CO2 trickles down over the canopy.
  • Bubble test: spray soapy water on the connection, open the tank, and watch for bubbles before you trust the seal.
  • Programming: Sensor Trigger, CO2, set to 800 ppm. It turns on below 800 and shuts off once it gets there.
  • Optional settings: a buffer so it does not flicker on and off at exactly 800, and a maximum run time (5 minutes, say) so a stuck valve cannot empty the tank.
  • Turn on the photocell so it only doses while the lights are on.
  • Result: when the tent drops to 800 the regulator kicks in, the level jumps to about 1,000, then slowly trickles back down.

10% Off Store-Wide

Get My Code
Shop AC Infinity

Affiliate link. 218 Cultivation may earn a commission at no extra cost to you. Details.

More AC Infinity videos

All AC Infinity videos

Affiliate Partner · Real-World Testing